Arctic Cat DVX 250 2007, Руководство по обслуживанию

Страница: 113 / 146

7-3
7
INSTALLING
1. Install each shock absorber to the frame and
A-arm with cap screws and nuts. Tighten all
nuts to specifications.
2. Remove the ATV from the support stand.
Rear Shock Absorber
„
NOTE: Critical torque specifications are located
in Section 10.
REMOVING
1. Secure the ATV on a support stand to elevate the
wheels and to release load on the suspension.
2. Remove the rear shield plate from the swing
arm; then remove the lower shock mounting nut
and cap screw.
KM551A
„
NOTE: Support the swing arm with a block of
wood or other support to allow removal of the cap
screw.
KM555A
3. Remove the upper shock mounting nut and cap
screw; then remove the shock absorber from the
frame.
KM554
CLEANING AND INSPECTING
1. Clean the shock absorber in parts-cleaning sol-
vent.
2. Inspect the shock absorber body, bottom stop,
and rubber bushing for damage and leaking oil.
If any defects are found, replace the shock
absorber.
3. Inspect the spring, spring seat, and preload
adjustment nuts and threads for damage or cor-
rosion. If corrosion is present on the threads,
clean with a fine wire brush and oil lightly.
KM561A
! CAUTION
Do not tighten the nut beyond the recommended
specification or the shock eyelet or mount WILL be
damaged.
! WARNING
Make sure the ATV is solidly supported on the sup-
port stand to avoid injury.
Back to TOC Back to Section TOC
Next Back