Arctic Cat DVX 250 2007, Руководство по обслуживанию

Страница: 66 / 146

3-37
3
8. Inspect transmission housing and cover for
cracks, scoring or galling of bearing bores, or
case discoloration.
9. Inspect the drive and driven bevel gears for
chipping, flaking, or excessive wear in the
splines. Replace as required.
KM422
10. Inspect the secondary driven bevel gear housing
for cracks, loose bearings, or signs of discolora-
tion from heat. Replace as required.
11. Inspect the driven shaft for scoring, discolora-
tion, or worn splines.
KM421
Assembling
1. Using the appropriate bearing and seal drivers,
install any required bearings and seals in the
transmission case and case cover.
KM696
2. Replace any required bearings and seals in the
secondary driven bevel gear shaft case. Apply
oil to all seal lips.
KM695
3. Apply oil to the secondary driven bevel gear
shaft; then install the bearing into the case.
KM420
4. Install the flat thrust washer and driven bevel
gear on the shaft; then using the universal joint
and vise to hold the shaft, install a new nut and
tighten to specifications.
Back to TOC Back to Section TOC
Next Back