Arctic Cat DVX 250 2007, Руководство по обслуживанию

Страница: 17 / 146

2-8
Engine Oil - Filter
Replace the engine oil and oil filter at the scheduled
intervals. The engine should always be warm when
the oil is changed so the oil will drain easily and
completely.
1. Park the ATV on level ground.
2. Loosen the oil fill plug.
KM126A
3. Remove the screen/filter cap from the bottom of
the engine and drain the oil into a drain pan.
Account for a spring, O-ring, and screen/filter.
DSC02248
4. Clean the screen/filter in parts-cleaning solvent;
then inspect the O-ring and replace if damaged.
5. Install the screen/filter, spring, and screen/filter
cap into the bottom of the engine and tighten to
specifications.
6. Remove the oil fill plug and pour in 1.6 L (1.7
U.S. qt) of the recommended oil into the fill
hole; then install the oil fill plug.
7. Start the engine (while the ATV is outside on
level ground) and allow it to idle for a few min-
utes.
8. Turn the engine off and wait approximately one
minute. Check the oil level in the engine oil
inspection window. The oil level should be visi-
ble through the window. If oil is not visible, add
recommended oil until the oil level is visible
between the lines of the window.
KM127A
9. Inspect the area around the screen/filter cap for
leaks.
Rear Drive Lubricant
(Utility Model)
Check and change the lubricant according to the
Periodic Maintenance Chart. When changing the
lubricant, use approved SAE 80W-90 hypoid gear
lube. To check lubricant, use the following proce-
dure.
1. Remove the rear drive level plug; the lubricant
level should be at the threads of the plug.
! CAUTION
Any oil used in place of the recommended oil could
cause serious engine damage. Do not use oils which
contain graphite or molybdenum additives. These
oils can adversely affect clutch operation. Also, not
recommended are racing, vegetable, non-detergent,
and castor-based oils.
Back to TOC Back to Section TOC
Next Back