Arctic Cat DVX 250 2007, Руководство по обслуживанию

Страница: 56 / 146

3-27
3
KM411
4. Carefully lift the reel free of the case making
sure the spiral spring does not accidentally dis-
engage from the case.
KM402A
5. Remove the protective cover from the starter
handle and pull the rope out of the handle; then
untie the knot in the rope and remove the han-
dle. Account for a flat washer.
KM408
„
NOTE: Do not remove the spiral spring unless
replacement is necessary. It should be visually
inspected in place to save time. If replacement is
necessary, follow steps 6-7.
6. Remove the spiral spring from the case by lift-
ing the spring end up and out. Hold the remain-
der of the spring with thumbs and alternately
release each thumb to allow the spring to gradu-
ally release from the case.
7. Unwind the rope from the reel and remove the
rope.
Cleaning and Inspecting
„
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all components.
2. Inspect the springs and ratchet for wear or dam-
age.
3. Inspect the reel and case for cracks or damage.
4. Inspect the shaft for wear, cracks, or damage.
5. Inspect the rope for breaks or fraying.
6. Inspect the spiral spring for cracks, crystalliza-
tion, or abnormal bends.
7. Inspect the handle for damage, cracks, or deteri-
oration.
Assembling/Installing
1. If removed, insert the spiral spring into the case
with the outer end of the spring around the
mounting lug in the case; then wind it in a coun-
terclockwise direction until the complete spring
is installed.
„
NOTE: The spiral spring must seat evenly in the
recoil case.
KM402
2. Insert the rope through the hole in the reel and
tie a knot in the end; then wrap the rope clock-
wise around the reel leaving approximately 50
cm (20 in.) of rope free of the reel.
! WARNING
Care must be taken when lifting the reel free of the
case. Wear safety glasses to avoid injury.
Back to TOC Back to Section TOC
Next Back