Arctic Cat DVX 250 2007, Руководство по обслуживанию

Страница: 63 / 146

3-34
3. Zero the indicator and rotate the crankshaft
slowly.
4. Maximum runout must not exceed specifica-
tions.
„
NOTE: Proceed to check runout on the other end
of the crankshaft by positioning the indicator con-
tact at point 2 and following steps 3-4.
Measuring Crankshaft
(Web-to-Web)
1. Using a calipers, measure the distance from the
outside edge of one web to the outside edge of
the other web.
ATV-1017
2. Acceptable width range must be within specifi-
cations.
CRANK BALANCER SHAFT
Inspecting
Inspect the gear teeth and bearing surfaces for chips,
discoloration, or excessive wear.
KM724
Servicing Right-Side
Components
„
NOTE: Whenever a part is worn excessively,
cracked, damaged in any way, or out of tolerance,
replacement is necessary.
TRANSMISSION (DVX Model)
Inspecting
1. Measure the shift fork guide shaft runout. If
runout exceeds 0.03 mm (0.0012 in.), the shaft
must be replaced.
KM623
2. Inspect the shift forks for distortion, discolora-
tion, scoring, or excessive wear.
3. Inspect the shift cam groove and shift cam gear
for excessive wear.
KM625
4. Inspect shift shaft and shift shaft gear for exces-
sive wear.
! CAUTION
Care should be taken to support the connecting
rod when rotating the crankshaft.
Back to TOC Back to Section TOC
Next Back