Apollo RoadRunner MR2B Series, Руководство по эксплуатации

Страница: 15 / 84

Mobile Digital Video Recorder
5
Rotary Timer Switch
0: Timer switch is not set. 5: 30-second delay boot and 15-minute delay shutdown
1: Two-minute delay shutdown 6: 30-minute delay shutdown
2:30-second delay boot and two-minute delay shutdown 7: One-hour delay shutdown
3: Five-minute delay shutdown 8: Two-hour delay shutdown
4: 15-minute delay shutdown 9: Eight-hour delay shutdown
Alarm Off Switch
Factory Reset Switch
CAUTION: When using the Factory Reset , you will lose any settings you have saved. If
you want to use the same DVR name registered on the DVRNS server after initializing
the system using the factory reset, you need to contact the DVRNS server manager.
Please record and save the help desk information before factory reset.
To reset the unit, you will need a straightened paperclip:
1. Turn the DVR off.
2. Turn it on again.
3. While the DVR is initializing, poke the straightened paperclip to the unlabeled hole in the right of
the RS485 connectors.
4. Hold the switch until the DVR is completely initialized.
NOTE: When the DVR successfully resets to factory defaults its live video will begin showing on
the monitor.
5. Release the reset switch. All of the DVR’s settings are now at the original settings it had when it
left the factory.
RS485 Port
The Rotary Timer sets how long it will delay to boot or shutdown the system operation after
the ignition switch is turned on or off. The white arrow indicates which number is selected,
and each digit on the rotary timer indicates as following:
Pressing the Alarm Off switch on the back panel resets any active alarms (outputs and DCP
buzzer).
The DVR has a Factory Reset switch to the right of the RS485 connectors in the rear
panel. This switch will only be used on the rare occasions that you want to return all the
settings to the original factory settings.
The DVR can be controlled remotely by an external device or control system, such as a control
keyboard, using RS485 half-duplex serial communications signals. The RS485 connector can
also be used to control PTZ (pan, tilt, zoom) cameras. Connect
TX+/RX+ and TX-/RX- of the
control system to the RX+/ TX+ and RX-/TX- (respectively) of the DVR. See Chapter 3 ─
Configuration and the PTZ camera or remote controller manufacture’s manual for configuring
the RS485 connection.