Anritsu MX183000A, Руководство по эксплуатации, Страница: 64 / 226

Chapter 4 Operation
4-10
4.3.4 RF Setting of MX180000A
When MX183000A is connected to MX180000A, Adjust RF appears in the
upper right of the screen shown in Figure 4.3.2-2. Click Adjust RF to
display the Adjusting dialog box of Figure 4.3.4-1 below.
Figure 4.3.4-1 Adjusting dialog box
While the Adjusting dialog box is displayed, the settings of the
MU181500B and MP1825B that are installed on the MP1800A can be
edited.
For main setting items, refer to Table 4.3.4-1.
Note:
While the Adjusting dialog box is displayed, do not click Return to
normal BERT mode in the 28G 32G PPG screen. (See Section 4.3.3
“Entering Compliance Test Mode”.) If clicked, disconnect this
software from the MX183000A and re-connect. (Refer to Section
4.3.2 “Connecting Measurement Equipment”.)
Click Finish after adjusting is completed.
Table 4.3.4-1 Setting Items for Adjusting
Module Setting Items
MU181500B Jitter Modulation
Source
SJ/SJ2
SSC
RJ
BUJ
MP1825B 4Tap Emphasis Cursor or coefficient values
Eye Amplitude value
For details of settings, refer to the following:
3.4 “Setting Jitter” in the MU181500B Jitter Modulation Source Operation Manual
7.10.3 “Jitter Setting Commands” in the MX180000A Signal Quality Analyzer Control Software
Remote Control Operation Manual
3.1.3 “MP1825B Control Screens” in the MP1825B 4Tap Emphasis Operation Manual
5.5.2 “Waveform Settings” in the MP1825B 4Tap Emphasis Operation Manual