Anritsu MX183000A, Руководство по эксплуатации, Страница: 47 / 226

3.2 Jitter Tolerance Test Connection Procedure
3-9
3
C
on
nec
tin
g E
qu
ip
m
en
t
1. When MX183000A is installed on a control PC, connect the control
PC to MP1800A with an Ethernet cable.
When MX183000A is installed on MP1800A, Ethernet cable
connection is not required.
MP1800A requires the MP1800A-x02 LAN option.
2. Set up as follows using the Remote Control tab on Setup Utility.
Activate Interface: Ethernet
Performance: Enhanced
3. Mount MU181000A/B-x01 and MU181500B in MP1800A-x02, x32.
4. Mount MU183020A in Slot 3 of MP1800A-x02, x32.
5. Mount MU183040A/B in Slot 4 of MP1800A-x02, x32.
6. Connect the Clock Output connector of MU181000A/B-x01 to the Ext
Clock Input connector of MU181500B with a coaxial cable.
7. Use BNC-SMA cables (J1508A) to connect the Ext.I,Q connector of
the MU181000A/B-x01 and the I,Q Output connector of the
MU181500B. (2 connections)
8. Connect the Jittered Clock Output connector of MU181500B and the
Ext. Clock Input connector of MU183020A using a coaxial cable.
9
.
If using Clock Recovery, proceed to Step 10.Use a coaxial cable to
connect the Clock Output connector of the MU183020A and the Ext
Clock Input connector of the MU183040A/B.
10. Connect the Data Output,
Data
Output connectors of MU183020A
to the Data Input,
Data
Input connectors of a device under test
with four coaxial cables.
11. Use coaxial cables to connect the Data Output and
Data
Output
connectors of the DUT and the Data Input and
Data
Input
connectors of the MU183040A/B.
12. Select MU181000A/B for Synthesizer Clock Source for the
MU181500B.
3.3 “Input Signal Settings” in the MU181500B Jitter Modulation
Source Operation Manua l
13. Select MU181500B in Clock Setting of the Misc2 tab of MU183020A.
5.6 “Misc2 Function” in the MU183020A 28G/32G PPG MU183021A
28G/32G 4ch PPG Operation Manual