Maintenance
6-4 Making a Connection
3659 0.8 mm Cal/Ver Kit & 2300-580-R PVS UG
PN: 10410-00327 Rev. D
6-9
4.
Before torquing, make sure long or heavy devices or cables are supported so there is no lateral pressure
on the connection
5.
Rotate
only
the connector nut when tightening the connection. Apply torque to the fitting until the handle
begins to break as shown in
.
Torque Specifications and Tools
Torque values are listed below for connectors used with the 365xx-x mechanical calibration kits. If you are not
sure which connector types are available on your instrument, consult the instrument Technical Data Sheet
available on the web at
.The ME7838G requires an adapter (33.8G50) to go from the module’s
flange-based interface to a 0.8 mm male connector. This adapter is attached to the module with hex screws and
a torque driver (3-85096, which is part of the ME7838G accessory kit) should be used to secure those screws.
Index
Description
1
Hold handle here
2
Handle begins to break - Stop torquing
3
Torque direction
4
Handle fully broken - Avoid torquing this far
Figure 6-12.
Using a Torque Wrench
Table 6-1.
Connector Torque Settings and Recommended Tools
Connector
Type/Size
Wrench
Size
Torque
Setting
Recommended Tools
3.5 mm
a
b
8
mm
5/16 in
0.9 N·m
8 lbf·in
01-201 5/16 in Torque End Wrench
01-204 5/16 in or 8 mm Open End Wrench
GPC-7
19 mm
3/4 in
12 lbf·in
1.36 N·m
01-200 3/4 in Torque End Wrench
K
(2.92 mm)
8 mm
5/16 in
0.9 N·m
8 lbf·in
01-201 5/16 in. Torque End Wrench
01-204 5/16 in. or 8 mm Open End Wrench
V
(1.85 mm)
8 mm
5/16 in
0.9 N·m
8 lbf·in
01-201 5/16 in. Torque End Wrench
01-204 5/16 in. or 8 mm Open End Wrench
W1
(1 mm)
6 mm
0.45 N·m
4 lbf·in
01-504 6 mm Torque End Wrench
01-505 6 mm x 7 mm Combination Open End Wrench
0.8 mm
6 mm
0.45 N·m
4 lbf·in
01-524 6 mm Torque End Wrench
01-525 6 mm x 7 mm Combination Open End Wrench
Handle begins to break
(correct point to stop)
Handle fully broken (avoid)
Hold handle here
Torque
direction
1
2
3
4