AMX Modero NXD-CV5, Руководство по эксплуатации/справочник

Страница: 27 / 162

Installation
21 5" Modero Widescreen Touch Panel
3.
Connect all data and power wiring connectors to their corresponding locations along the side of the
(un-powered) NXD touch panel.
Verify that the terminal end of the power cable is not connected to a power source before
plugging in the 2-pin power connector.
The USB connectors can be from either a USB extension cable, or a wireless USB RF
transmitter.
4.
Test the incoming wiring by connecting the panel connections to their terminal locations and
applying power. Verify that the panel is receiving power and functioning properly to prevent
repetition of the installation.
5. Disconnect the terminal end of the power cable from the connected power supply.
6. Carefully slide the main NXD-CV5 unit ( B in FIG. 18) into the rough-in box, so that all Mounting
Tabs lie flush against the rough-in box ( C in FIG. 18).
7.
Insert and secure three #4-40 Mounting Screws (included) into their corresponding holes located
along the sides of the NXD.
8. Place the Faceplate/Trim Ring ( A in FIG. 18) back onto the main NXD unit ( B in FIG. 18).
Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective
openings on the front faceplate/bezel.
9.
Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their
respective locations (
outside the rough-in box ) on either the NXA-AVB/ETHERNET Breakout Box,
Ethernet port, or NetLinx Master.
FIG. 18 NXD-CV5 panel installation into a CB-TP5 (pre-wall construction)
B - Main NXD unit consists of
C - Optional CB-TP5
#4-40 Mounting Screws
(three - included)
secure the NXD to
Stud
the touch panel and back box housing
rough-in/wallbox
A - Faceplate/Trim Ring
default Faceplate comes with buttons
the Rough-In Box
Mounting Tab
Don’t disconnect the connectors from the touch panel. The unit must be installed with
the attached connectors before being inserted into the rough-in box.