AMX Modero NXD-CV5, Руководство по эксплуатации/справочник

Страница: 46 / 162

Configuring Communication
40 5" Modero Widescreen Touch Panel
Step 5: Confirm and View the current AMX USB device connections
Use the CC-USB Type-A to Mini-B 5-wire programming cable ( FG10-5965 ) to provide communication
between the mini-USB Program port on the touch panel and the PC. This method of communication is
used to transfer firmware KIT files and TPD4 touch panel files.
1.
Verify this direct USB connection (Type-A on the panel to mini-USB on the panel) is configured
properly using the steps outlined in the previous two sections.
2.
With the panel already configured for USB communication and the Virtual Master setup within
NetLinx Studio, its now time to verify the panel is ready to receive files.
3.
Click the OnLine Tree tab in the Workspace window to view the devices on the Virtual System. The
default System value is one .
4.
Right-click on the System entry ( A in FIG. 38) and select Refresh System . This causes a refresh of
all project systems, establishes a new connection to the Virtual Master, and populates the System list
with devices on your particular system.
Configuring a Wired Ethernet Connection
It is necessary to tell the panel which Master it should be communicating with . This "pointing to a
Master" is done via the System Connection page where you configure the IP Address, System Number
and Username/Password information assigned to the target Master. Until those parameters are
configured, your Connection Status icon will remain red (
indicating there is no current connection to a
Master ).
A mini-USB connection is only detected after it is installed onto an active panel.
Connection to a previously powered panel which then reboots, allows the PC to
detect the panel and assign an appropriate USB driver.
FIG. 38 Using USB for Virtual Master communication