AMX Modero NXD-CV5, Руководство по эксплуатации/справочник

Страница: 32 / 162

Installation
26 5" Modero Widescreen Touch Panel
5.
Connect all data and power wiring connectors to their corresponding locations along the left side of
the (un-powered) NXD touch panel.
Verify that the terminal end of the power cable is not connected to a power source before
plugging in the 2-pin power connector.
The USB connectors can be from a either a USB extension cable, or a wireless USB RF
transmitter.
6.
Test the incoming wiring by connecting the panel connections to their terminal locations and
applying power. Verify that the panel is receiving power and functioning properly before finalizing
the installation.
7.
Disconnect the terminal end of the power cable from the power supply.
8.
Carefully slide the main unit into the cutout until the Mounting Tabs of the CV5 unit lie flush
against the wall.
9.
Insert and secure three #4 Mounting Screws (not included) into their corresponding holes located
along the sides of the NXD-CV5 (using a grounded Phillips-head screwdriver) until the unit is
secure and flush against the wall (FIG. 22).
FIG. 22 Wall Mount panel installation configuration for flat surfaces
B - Main CV5 unit
Install the three #4 Mounting Screws
Flat installation surface
A - Faceplate/Trim Ring
Mounting Tab
Attachment is done
along the edges
of the cutout
(not included) into these three holes
(suggested length of screws is 0.25")
Don’t disconnect the connectors from the touch panel. The unit must be installed with
the necessary connectors before being inserted into the solid surface.