AMX Modero NXD-CV5, Руководство по эксплуатации/справочник

Страница: 19 / 162

Installation
13 5" Modero Widescreen Touch Panel
Installation
This NXD panels can be installed into either a pre-wall surface (using a CB-TP5 rough-in/wallbox) or a
solid surface (using either solid surface or drywall screws).
Unpacking the Panel
1.
Inspect and confirm the contents of the shipment box to verify you have all specified parts. Refer to
the
Specifications for 5" Widescreen Video Touch Panel section on page 2 for more information
about included accessories and other AMX equipment.
2. Carefully remove the panel from the shipping box.
3.
Carefully peel the protective plastic cover from the LCD.
Installing the No-Button Trim Ring
The NXD-CV5 panel is shipped from AMX with the default Button Trim Ring already installed. The
unit is also shipped with an included Trim Ring containing no button openings (a No-Button Trim Ring)
that allows you, if desired, to change the default configuration of the NXD panel Faceplate to that with
no-button openings. In order to install this included No-Button Trim Ring, you must first remove the
factory-installed default Button Trim Ring and its six small buttons.
1. The Faceplate is secured to the panel with plastic latches. To remove the Faceplate, simply pull it
away from the panel by gently tugging it outwards until the entire Faceplate comes away from the
panel.
2.
Turn the Faceplate over to expose the inside surface and view the Trim Ring latches (FIG. 10).
3. In a single motion, press down and then outwards on the two Trim Ring latches located along the
top of the internal surface of the Faceplate to begin removing the Button Trim Ring.
Removing the
Internal Faceplate from the panel exposes the pushbuttons along the inside of the Internal
Faceplate.
4. Gently tug along the edges of the Button Trim Ring and work your way around the edges to remove
it from the Faceplate (FIG. 10).
5.
From along the internal surface of the Faceplate, remove the six buttons by gently bending each
Button latch up and pulling the button outwards.
6. Grasp the No-Button Trim Ring on both sides and fit it into the groove along the outside surface of
the Faceplate (made available by the removal of the previous Trim Ring).
7.
Gently insert the Trim Ring latches into their corresponding openings on the outer surface of the
internal Faceplate (FIG. 11).
If the protective plastic LCD cover is not removed, the panel may not respond
properly to touch points on the LCD or allow proper screen calibration.