Using the DXP-HT Project Wizard
41
DXP-HT v1.3 - Programmer’s Guide
(Dynalite)
:
K:P:[14]:12:25
indicates area #14, go to preset scene #12 at 25-second
fade rate.
The
Clear
button clears the
Preset Name
,
Address
and
Button Number
information for a
selected preset.
Resorting the Presets List:
Select a Preset and click the up/down arrows (to the right of the Lighting Presets table) to rearrange
the order of the list.
Note for ALD-D48 Lighting Systems
The ALD-D48 is not controlled by Send Commands, so each button on the touch panel or keypad
corresponds to a specific dimmer.
For instructions on developing NetLinx code to program scenes for the D48, refer to Tech Note #
TN 543, available via www.amx.com (Dealers > Tech Center > Tech Notes).
For detailed configuration information on the ALD-D48, refer to the ALD-D48 Network Lighting
Solution Instruction Manual, also available via www.amx.com (Dealers > Tech Center > Tech Docs
> Instruction Manuals).
Note for Radia Lighting Systems
On Radia lighting systems, channels 1-128 represent Radia lighting presets 1-128. If a channel is
on, then the corresponding preset is on. However, on startup NetLinx resets all channels to 0 (OFF).
Radia does not report the status of its channels when the master comes up, and consequently the
software believes the state of all of the presets is OFF. Therefore, until a preset changes in the
system, the channel states are not reported.
It is important to have the Lighting Preset information prior to finishing the project.
Enter a new
Preset Name
,
Address
and
Button Number
, and click the
Add
button to add a
new preset to the bottom of the list.
Select a Preset in the list and click the
Delete
button to delete that preset from the list.
The
Insert
button inserts a new preset at the order number of the currently selected
preset.
Click the
Apply
button after editing a preset to apply the changes.
The
Clear
button clears the
Preset Name
,
Address
and
Button Number
information for a
selected preset.
