Using the DXP-HT Project Wizard
36
DXP-HT v1.3 - Programmer’s Guide
Audio/Video Inputs dialog
The Audio/Video Inputs dialog creates the association between the Devices defined on the System
Information dialog, the Inputs defined for the receiver, and the physical input connectors on the
back of the receiver. Each source Device must be associated with a Physical Label, an Input Type
and the IR or Control Logic command required to switch the receiver.
Use the Audio/Video Input dialog to label the audio and video inputs on the primary receiver in the
system.
This dialog contains the
Inputs to Receiver
table, which consists of several columns. The
Input
Type
,
Physical Label,
Input Command
(and
Display Device Input,
if applicable) fields can be edited
in the combo boxes in the bottom half of this dialog:
The combo boxes in the lower half of this dialog allow you to populate the Inputs to Receiver table:
FIG. 7
Audio/Video Inputs dialog
• Display Name:
This column is a list of all source devices currently in the system.
• Physical Label:
This column indicates the physical label (on the receiver) that is associ-
ated with the device, as specified in the Physical Label text field in the
lower half of this dialog. The Physical Label is for installation purposes
only and is intended for the installer's reference in the generated report
file. You can edit this information via the Physical Label text box at the
bottom of this dialog.
• Input Type:
This column differentiates audio-only inputs from Audio/Video Inputs.
This is important when using a RS-232 Control Logic.
• Display Device Input: For A/V inputs only, this column indicates the display device input, as
specified in the Display Device drop-down at the bottom of this dialog.
• Display Name:
This read-only field indicates the Display Name assigned to the device in
the System Information dialog.
