To clear all settings for multiple ports click and hold the trackball button on the first System Name of the ports to
be cleared, drag down the list until the last port to be cleared is selected, release the trackball button and click
the Clear button.
To clear multiple entries in a single column click in the column containing the entries to be cleared, click and
hold the trackball button on the first entry to be cleared, drag down the list until the last port to be cleared is
selected, release the trackball button and click the Clear button.
Delay
To set Delay Units click on the Delay Units button.
A dialogue box will appear containing the options for Delay Units.
Select the required units and click OK.
The legend on the Delay Units button will change to indicate the selected Units.
The Remaining amount will display the amount of Delay left to assign in the new Units.
Any Delay configured will change to show the setting in the new Units.
To configure Delay on single ports double click in the Delay column for the required port. A box will appear with
an X next to it. Enter the amount of Delay from the Encore keyboard and press ENTER on the Encore keyboard.
Auto Increment and Auto Copy can be used when entering delay times.
To automatically configure Delay on multiple ports click in the Delay column, click and hold the trackball button
on the first Delay entry to be configured, drag down the range of ports to configure, release the trackball button
and click on the Auto Configure Delay button.
The delay Remaining will be divided equally amongst the highlighted ports leaving a remainder which will be
the new Remaining amount.
Any Delay already assigned to the selected ports will be added to the Remaining amount before it is divided up.
Dither
This allows noise to be added to an Output port so that the noise content of a signal is redistributed over the
whole frequency spectrum to eliminate noise peaks.
Dithering is 16, 18, 20 or 24-Bit with an LSB Rounding, Rectangular or Triangular pattern.
To set Dither on Output ports click on the Outputs radio button. The list will show Output ports.
Click on the Type radio button as required and double click on the Dither entry for the required port. A drop
down list of Dither settings will appear.
Double click on the required setting.
Auto Increment and Auto Copy can be used when setting dither.
Tools Menu
I/O Config
Issue 4
Page 24:18