Ametek Sorensen Asterion DC ASM, Руководство по программированию

Страница: 45 / 162

Asterion DC Multioutput Series
Programming Manual
6-28
M330517-01 Rev C
5. Enter the Gateway Address (Refer to Figure 6-9).
6.
Press “Apply Now” button for the settings to take effect.
7. The Asterion DC Multioutput Series power supply Ethernet hardware is now
configured. Open Web browser and enter the IP address of the power supply to view
the Home page. Refer to Figure 6-12.
6.4.3.2
S
TATIC
IP
SETUP USING THE SERIAL INTERFACE
1. Connect using a computer serial communications program such as Tera Term, set for
the same baud as Asterion DC Multioutput Series power supply (Refer to Figure 6-5)
no parity, 8 data bits, 1 stop bit. Refer section 4.2.2 for more details.
2. Turn OFF DHCP mode using the SCPI command, SYST:NET:DHCPMODE 0.
3. Refer to section 10.8 for more details on SCPI commands.
4. Set the IP address by issui
ng SYST:NET:IP “xxx.xxx.xxx.xxx” (where xxx.xxx.xxx.xxx
is the new IP address). For example, to set 192.168.0.200 as the IP address, type
SYST:NET:IP “192.168.0.200”.
NOTE: The format requires a single space after SYST:NET:IP and double quotes
around the IP address numbers.
5. Set the subnet mask with SYST:NET:MASK xxx.xxx.xxx.xxx.
6. Set the gateway with SYST:NET:GATE xxx.xxx.xxx.xxx.
7. Type SYST:NET:APPLY, press enter to apply the Static IP configuration.
8. After configuring all settings, verify with the queries, SYST:NET:IP?,
SYST:NET:GATE? and SYST:NET:MASK?.
9. The Asterion DC Multioutput Series power supply Ethernet hardware is now
configured. Open Web browser and enter the IP address of the power supply to view
the Home page. Refer to Figure 6-12.
10. Programming/Communication Via Ethernet
With the Ethernet option, there are three basic methods to communicate with the
power supply from a PC:
•
Raw socket interface, sending delimited strings
•
Application program that utilizes VXI-11 Discovery protocol
•
Web browser
6.4.4
Raw Socket Interface
The essential components of communicating via a raw socket interface are the socket
number, IP address and command delimiter. The default values are socket = 52000, IP
address = 192.168.0.200 (when DHCP is disabled), and delimiter = line feed <CRLF>.
We can set the static IP address, Subnet Mask and Gateway using web browser (refer to
Section 0) or the RS232C interface.
6.4.5
VXI-11 Protocol
With programs s
uch as National Instrument’s NI-VISA, the VXI-11 protocol allows the