Ametek Sorensen Asterion DC ASM, Руководство по программированию

Страница: 126 / 162

Asterion DC Multioutput Series
Programming Manual
M330517-01 Rev C 12-109
Delete all sequences from non-volatile memory using the following command:
PROG<n>:DEL:ALL
EXAMPLE 1
Issue
*RST
to reset the unit to a known state.
To create a sequence named
“SEQ1”, first issue the NAME command as follows:
PROG<n> :NAME “SEQ1”
If you query the state of the selected sequence, it responds EMPTY.
PROG
<n>:
STAT?
Response:
“EMPTY”
Then memory needs to be allocated to the newly named SEQ1 sequence:
PROG
<n>
:MALL DEFAULT
After memory has been allocated, the state of the SEQ1 sequence is EDIT, as the
following query shows:
PROG
<n>
:STAT?
Response:
“EDIT”
Once the sequence is in the EDIT state, we are ready to send a sequence of programming
steps to define a sequence of power supply settings:
PROG
<n>
:DEF 1, VIMODE,3,4,11,10
//go to 3 volts, 4 amps, 11 volts ovp,
for 10 seconds
PROG
<n>
:DEF 2, RAMPTOV,3,5,4,11,10
//ramp from 3 to 5 volts in 10 sec.
PROG
<n>
:DEF 3, VIMODE, 5, 4, 11, 10
//hold 5 volts for 10 seconds
PROG
<n>
:DEF 4, RAMPTOV, 5, 3, 4, 11, 10
//ramp from 5 to 3 volts in 10 sec.
PROG
<n>
:DEF 5, VIMODE, 3, 4, 11, 10
//hold 3 volts for 10 seconds
PROG
<n>
:DEF 6, STOP
//stops running the sequence while the
unit remains at the state of the last
command within the sequence.
Only 6 steps are intended for this example, so the sequence is complete. To take the
sequence out of the EDIT state, it needs to be sent to the COMPLETE state, which
becomes the STOPPED state, using the following command:
PROG
<n>
:STAT COMPLETE
PROG
<n>
:SAVE:SEL
PROG
<n>
:STAT?
Response: State: STOPPED
Once in the STOPPED state, the sequence is ready to run again. To rerun the sequence,
issue the following two commands:
OUTP
<n>
:STAT ON