Ametek Sorensen Asterion DC ASM, Руководство по программированию

Страница: 91 / 162

Asterion DC Multioutput Series
Programming Manual
10-74
M330517-01 Rev C
Command Description SCPI
SOURce<n>:VOLTage:PROGram:FSCR?
Returns the Full-scale Resistance, at which Full
scale Voltage will be programmed.
N
SOURce<n>:VOLTage:MONitor:FSC <NRf>
Sets Full Scale voltage on voltage monitor
pin(VMON), when power supply is producing full
scale output voltage.
N
SOURce<n>:VOLTage:MONitor:FSC?
Returns the full-scale voltage set for Voltage
monitor pin (VMON)
N
SOURce<n>:POWer <NRf>
Sets the maximum power limit C
SOURce<n>:POWer?
Returns the set power. C
SOURce<n>:POWer:MAXimum?
Returns the Maximum power that can be
programmed with given hardware configuration
and Input voltage conditions.
N
SOURce<n>:POWer:LIMit <NRf>
Sets an upper soft limit on the programmed
output power for the supply. The soft limit
prevents the supply from being inadvertently
programmed above the soft limit, thus providing a
method for protecting the load against damaging
power.
N
SOURce<n>:POWer:LIMit?
Returns the upper soft limit on the programmed
output power for the supply.
N
SOURce<n>:ANALOG:PROGram:SOURce <string>
Changes the source for EXTernal analog
programming Mode. Valid arguments are VOLT
and CURR.
VOLT
– Voltage source (0-10V range)
CURR
– Resistive load on constant 1mA source
(0-10kOhm). 1mA current source is in built in
power supply.
N
SOURce<n>:ANALOG:PROGram:SOURce?
Returns the setting of External analog
programming source.
N
SOURce<n>:ANALOG:REMote:OUTPut <NRf>
Enable/Disable the Remote output ON/OFF
feature.
0 = Disables the Remote output ON/OFF feature.
1 = Enables the Remote output ON/OFF feature.
N
SOURce<n>:ANALOG:REMote:OUTPut?
Returns the state of the Remote output ON/OFF
feature.
N
10.5.3
RAMP FUNCTION
The ramp function allows the user to transition from one voltage or current to another
linearly in a specified time period (100 ms - 99 sec with 100 ms programming resolution).
A unit may ramp only voltage or current, not ramping both at a given time.
For example,
SOUR<n>:VOLT:RAMP:TRIG 1 1
followed by
SOUR<n>:CURR:RAMP:TRIG 2 2
will cause the unit to ramp only the output current to
2 amps in 2 seconds upon the
TRIG:RAMP
command.
10.5.3.1
V
OLTAGE RAMPING TO A HIGHER VOLTAGE
Requires a programmed current of at least 20% of the full-scale value. Settings less than
20% will significantly lengthen the ramp time due to charging of the large capacitance in
the output section of the power supply.