Amazone EDX 9000-TC, Руководство по эксплуатации

Страница: 32 / 246

General Safety Instructions
32 EDX 9000-TC BAH0048-6 09.2019
Implement transportation

When using public roads, national road traffic regulations must
be observed.

Before moving off, check:

the correct connection of the supply lines,

the lighting system for damage, function and cleanliness,

that the brake and hydraulic system shows no visible signs
of defect,

that the tractor parking brake is released completely

the function of the brake system.

Ensure that the tractor has sufficient steering and braking power.
Any implements and front/rear weights connected to the tractor
influence the driving behaviour and the steering and braking
power of the tractor.

If necessary, use front weights.
The tractor front axle must always be loaded with at least 20 %
of the tractor tare weight, in order to ensure sufficient steering
power.

Always fix the front or rear weights to the intended fixing points
according to regulations.

Comply with the maximum payload of the connected implement
and the permissible axle and drawbar loads of the tractor.

The tractor must guarantee the prescribed brake delay for the
loaded vehicle combination (tractor plus connected implement).

Check the brake power before moving off.

When turning corners with the implement coupled, take the wide
sweep and centrifugal mass of the implement into account.

Before moving off, ensure sufficient side locking of the tractor
lower links, when the implement is fixed to the three-point
hydraulic system or lower links of the tractor.

Before road transport, move all the swivel implement parts to the
transport position.

Before road transport, secure all the swivel implement parts in
the transport position against risky position changes. Use the
transport locks intended for this.

Before road transport, secure the operating lever of the three-
point hydraulic system against unintentional raising or lowering
of the coupled implement.

Check that the transport equipment, e.g. lighting, warning
equipment and protective equipment, is correctly installed on the
implement.

Before road transport, carry out a visual check that the top and
lower link pins are firmly fixed with the linch pin against
unintentional release.

Adjust your forward speed to the prevailing conditions.

Before driving downhill, switch to a low gear.

Before road transport, always switch off the independent wheel
braking (lock the pedals).

Observe the maximum permissible total weight. Only transport
the implement with empty seed and fertiliser hoppers.