Amada MAWA-300B-00-00, Руководство по эксплуатации, Страница: 106 / 168

MAWA-300B
4. Explanation of Screens
4-43
(19) Set Values of Each Screen at Delivery from the Factory
The following table shows initial set values of each screen at delivery from the factory. When the
memory was initialized on the Switch select screen, these initial values are provided.
Screen Parameter Initial value
Device No. 1
Language selection English
Brightness adjustment 08
EX comm type OFF
Communication speed 9600
Basic setting
screen
Internal resistance OFF
NG judgment error OFF
Start parity error ON/OFF OFF
SCH & Torch select by I/O OFF
Measurement current select RMS
Measurement voltage select RMS
Enable START switch ON
Internal Gas Flow ON
High speed SCH change (No Wave) OFF
Fine Weld Mode OFF
Torch drive type (*1) CYLINDER
GOOD/NG signal output time 200 [ms]
END signal output time 200 [ms]
START signal input delay time 20 [ms]
SCH changeover delay time 20 [ms]
H-END output time (*1) 200 [ms]
H-RESET output time (*1) 200 [ms]
H-HEAD UP output time (*1) 200 [ms]
Switch select
screen
ALL-WELD count 0
User input terminal 1 00: Not selected
User input terminal 2 00: Not selected
User output terminal 1 06: LOST
User output terminal 2 05: READY
User output terminal 3 03: END
User output terminal 4 07: WEL1 LOWER CURRENT
User output terminal 5 08: WEL1 UPPER CURRENT
User output terminal 6 17: WEL2 LOWER CURRENT
External I/O
setting screen
User output terminal 7 18: WEL2 UPPER CURRENT