174
Chapter 13: Using the Effects
1 Link parameter
The Link parameter appears on the FX 1 and FX 3 screens. If you select the COMPRESSOR/LIMITER effect for the FX 1 and
FX 2 (or FX 3 and FX 4) and set the Link parameter for the FX 1 (or FX 3) to ON, the FX2 (or FX 4) parameters will use the
FX 1 (or FX 3) parameter settings. If you did not select the COMPRESSOR/LIMITER effect for the FX 2 and FX 4, the Link
parameter setting will be ignored. The Link parameter is useful when you wish to apply the compressor/limiter effect to a
stereo signal source.
EXPANDER
This monaural effect limits signals at a certain level (threshold) or lower and expands the dynamic range, provid-
ing an effect opposite to the compressor effect.
1
2
3
4
5
6
7
8
Parameter
Setting range
Function
1
Thresh *1
–60dB – 0dB
Adjusts the level at which the effect is enabled.
2
Ratio *2
2:1 – 100:1
Adjusts the compression ratio for signals that is lower than the threshold
value.
3
Output *3
–20dB – +20dB
Adjust the level of the effect sound.
4
Attack *4
0 – 127
Adjusts the attack time of the effect.
5
Release *5
0 – 127
Adjusts the release time of the effect.
6
Hold *6
0 – 127
Adjusts the hold time of the effect.
7
Link
ON/OFF
Selects whether or not the FX 1 (FX 3) settings are used by the FX 2 (FX 4)
parameters. (See above “Link parameter” on this page.)
8
Effect
ON/BYPASS
Selects whether the effect is enabled (ON) or bypassed (BYPASS).