Advantech EKI-9312P Series, Руководство пользователя

Страница: 198 / 286

M
ANAGEMENT
I
NTERFACE
Interface Configuration
The MLD Snooping Interface Configuration page allows users to configure the settings for
MLD snooping. To access this page, click Multicast > MLD Snooping > Interface
Configuration .
Figure 3-136. Multicast > MLD Snooping > Interface Configuration
The following table describes the items in the previous menu.
Table 3-133. Multicast > MLD Snooping > Interface Configuration
Parameter Description
Interface Click the drop-down menu to select the single select box lists all physical, VLAN
and LAG interfaces. Select the interface you want to configure.
Admin Mode Click the drop-down menu to enable or disable the interface mode for the selected
interface for MLD Snooping for the switch. The default is Disable.
Group Membership Enter the amount of time you want the switch to wait for a report for a particular
Interval (secs) group on a particular interface before it deletes that interface from the group. The
valid range is from 2 to 3600 seconds. The configured value must be greater than
Max Response Time. The default is 260 seconds.
Max Response Time Enter the amount of time you want the switch to wait after sending a query on an
(secs) (Less Than interface because it did not receive a report for a particular group on that interface.
Group Membership Enter a value greater or equal to 1 and less than the Group Membership Interval in
Interval) seconds. The default is 10 seconds. The configured value must be less than the
Group Membership Interval.
Multicast Router Enter the amount of time you want the switch to wait to receive a query on an inter-
Present Expiration face before removing it from the list of interfaces with multicast routers attached.
Time (secs) Enter a value between 0 and 3600 seconds. The default is 0 seconds. A value of
zero indicates an infinite timeout, i.e. no expiration.
Fast Leave Admin Enter the Fast Leave mode for a particular interface from the pull-down menu. The
Mode default is Disable.
Submit Click Submit to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
186