Adtech ADT-DK300A, Руководство производителя

Страница: 99 / 172

BZ001M056A ADT ‐ DK300A/400A Engraving Machine
90
Note : 0 ‐ Program home
1 ‐ Mechanical home
Program home is that the coordinates go to home, i.e. in place.
Mechanical home requires external detection switch to locate the home
position; while home operation, move to specified home direction at
home speed, and move back slowly after signal is detected. At this
moment, move forward slowly when the signal is disconnected, and the
home operation completes when the signal is valid again. When the
servo Z phase enable switch in IO configuration parameters is enabled,
mechanical home will enable Z phase positioning as home position
automatically after signal reaches.
037 IO FilterWave(1~8)
Range : 0~8
Unit : None
Authority : Operation admin or higher
Default : 0
Effective time : Instant
Note : Set the filter constant;
If the environment has too much interference, e.g. rain and thunder,
please enter a filter value. Higher value indicates longer test time and
high reliability; 0 indicates no filter;
038 Communication mode
Range : 0~3
Unit : None
Authority : Operation admin or higher
Default : 0
Effective time : Restart
Note : Set the communication mode of the system;
System can communicate through the serial port, network and PC or
other device, 0 is Uart serial port, 1 is network communication, 2 is
NoUser and system communication is turned off;
040
MaxMPGSpeed(mm/min)