ACS S10 Series, Руководство пользователя

Страница: 16 / 51

Chapter 2 Precautions for Operation
S10 Screenless Granulator 882.12058.00 • 05-01-2019 11
Heading Item Precautions
CAUTION
Casters Be sure to lock the casters in two positions, except when moving
the granulator.
CAUTION
Initial crushed material
It is necessary to
dispose of the initial
crushed material
batch after delivery as
foreign material such
as antirust oil, metallic
powder, etc. is mixed
in it, and dispose of
them sufficiently.
●
After delivery, dispose of the first batch of crushed material.
Foreign materials such as antirust oil, and metallic powder is
mixed in the first crushed material.
●
Disposes of it sufficiently so that there is not any foreign
material mixed in. Observe descaling of dark regrind material
after granulation, and then clean the unit to check for foreign
material, before starting a cycle of regrind material.
●
Also discard any crushed material according to the above
points in order to remove foreign material or fine particles,
antirust oil, rust, etc. that have mixed into the unit for material
changes, after long-term operation pauses, too.
4. Precautions for operating
Heading Item Precautions
DANGER
Feed hopper
lower part of granulator
Do not insert hands inside the feed hopper and lower part
of granulator during operation.
The rotating cutters are sharp. Do not touch cutters when
stopped, as well.
DANGER
Feed hopper
The feed hopper should be closed while running. The following
fastening areas
( ※ )
should be completely fastened.
※
the rotating lock at the back of the hopper pivot
If the fastening area is not fastened well, if it gets loose in
running, it will fall down and be fully open. That is very
dangerous.
Do not look inside the feed hopper during operation.
Plastic materials scatter, and there is danger that material will
strike your face.
WARNING
Feeding runners Ideally, insert a single runner only.
It may cause cutter damage and issues when multiple runners are
inserted.
WARNING
Control box Do not open the control box except when necessary.
There is a danger of electrical shock, and may cause trouble and
accidents.
Do not jar the controller, and do not spray it with water.
These actions may cause issues and / or fire.
WARNING
Take-away bin If the operation is continued with the take away bin full, the
rotating cutters scoop up regrind material from the bin, and the
scrapers cut the regrind, causing bends or damage. Do not
operate with the bottom box full.