ACS S10 Series, Руководство пользователя

Страница: 10 / 51

Chapter 1 For Your Safety Operation
S10 Screenless Granulator 882.12058.00 • 05-01-2019 5
3. About labels
Labels are attached to this product at positions where attention is
required by the degree of danger. Before starting operation be sure to
fully understand the instructions with the WARNINGs and CAUTIONs.
Maintenance of labels
●
Keep labels legible until you dispose of this unit.
●
If labels become dirty, wipe with a soft cloth that has been soaked in water or hot water
under 104° F / 40 ° C and well wrung out. Do not use petroleum-based solvents and thinners,
at any time.
Contents of labels
Caution on cutting hands and fingers
1. Pay attention to feed hopper parts during operation
2. Pay attention to the lower part of the granulator
during the operation.
The rotating cutters of the granulator rotate at
high speed.
Do not insert hands inside the feed hopper
and the lower part of the granulator during
operation.
The rotating cutters are sharp. Do not touch
cutters during a stop as well.
Please run the machine after tightening up
the following fastening parts (※)
※ the rotating lock at the back of the hopper
switch pivot
Make sure to fasten the fastened areas before
starting the machine. If not fastened, and it
becomes loose while running, it will fall down
and be fully open.
Once the hopper is open, the limit switch breaks
contact. At that moment, the machine seems to
stop, but the rotating cutter will rotate for about
half-round because of inertia.
Such a situation is very dangerous, so the
fastening part need to be fastened well, while
running.
The fastened areas can only be loosened when
the machine is completely stopped.
Even when the machine is stopped , the rotating
cutters are still very sharp. Please pay attention,
and do not to touch them carelessly.