87
Chapter 3
Installing and Removing a PCI Add-in Card
Installing a PCI Add-in Card
In the slots provided by the PCI riser connector, you can install either one or two add-in cards. Use the
following instructions to install an add-in card.
1.
Observe the safety and ESD precautions at the beginning of this book. See
“Safety Information.”
2.
Power down the server and unplug all peripheral devices and the AC power cable.
3.
Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”
4.
Pull up on the two latches on the assembly. See letter “A” in the figure below.
5.
Lift the PCI riser assembly from the chassis.
6.
Open the PCI retention clip on the PCI riser card assembly. See letter “A” in the figure below.
7.
Remove the filler panel at the back of the riser assembly. See letter “B” in the figure below.
8.
Insert the add-in card until it seats in riser card connector. Make sure the bracket inserts into the matching
slot. See letter “C”.
9.
Close the retention clip. See letter “A” in the figure.
10.
Position the riser assembly over the PCI sockets on the server board (see letter “A” in the figure below),
lining up the four hooks at the rear of the riser assembly (see letter “B”) with the four slots in the rear of the
chassis (see letter “C”).
11.
Push the riser assembly down until the assembly is securely seated..
12.
Install the chassis cover. For instructions, see
“Installing the Chassis Cover.”
13.
Plug all peripheral devices and the AC power cable back into the server.
Содержание Altos R510
