Acer Altos R510, Руководство по обслуживанию

Страница: 87 / 143

Chapter 3 80
5. Open the connector labeled “Floppy Con” on the backplane by pulling up on the connector cover. Remove
the flat flex cable from the backplane.
6. Push in on the lever at the rear of the floppy carrier and slide the drive from the front of the chassis.
7. Open the connector cover on the rear of the floppy drive by pulling up on it. Release the flat flex cable
from the drive.
8. Remove the two screws at each side that hold the drive rails to the drive carrier. Lift the two rails from the
carrier.
9. Disconnect the two screws attaching the drive to the converted hard drive bay carrier.
10. Install an empty hot-swap hard drive carrier into chassis drive bay if no floppy or hard drive is to be
installed into the bay.
11. Store the screws, the converted drive bay carrier, the side rails, and the flat flex cable for future use.
12. Install the chassis cover. For instructions, see
13. (Optional) Install the front bezel.
14. Plug all peripheral devices and the AC power cable back into the server.