Acer Altos R510, Руководство по обслуживанию

Страница: 105 / 143

Chapter 4 98
Problems following Initial System Installation
Problems that occur at initial system startup are usually caused by an incorrect installation or configuration.
Hardware failure is a less frequent cause. If the problem you are experiencing is with a specific software
application, see "Problems with Newly Installed Application Software."
First Steps Checklist
T
Is AC power available at the wall outlet?
T
Are the power supplies plugged in? Check the AC cable(s) on the back of the chassis and at the
AC source.
T
Are all cables correctly connected and secured?
T
Are the processors fully seated in their sockets on the server board?
T
Are all standoffs in the proper location and not touching any components, causing a potential
short?
T
Are all add-in PCI boards fully seated in their slots on the server board?
T
Are all jumper settings on the server board correct?
T
Are all jumper and switch settings on add-in boards and peripheral devices correct? To check
these settings, refer to the manufacturer's documentation that comes with them. If applicable,
ensure that there are no conflicts-for example, two add-in boards sharing the same interrupt.
T
Are all peripheral devices installed correctly?
T
If the system has a hard disk drive, is it properly formatted or configured?
T
Are all device drivers properly installed?
T
Are the configuration settings made in Setup correct?
T
Is the operating system properly loaded? Refer to the operating system documentation.
T
Did you press the system power on/off switch on the front panel to turn the server on (power on
light should be lit)?
T
Is the system power cord properly connected to the system and plugged into a NEMA 5-15R outlet
for 100-120 V~or a NEMA 6-15R outlet for 200-240V~?
T
Are all integrated components from the tested components lists? Check the tested memory, and
chassis lists, as well as the supported hardware and operating system list.