Acer Altos R510, Руководство по обслуживанию

Страница: 109 / 143

Chapter 4 102
Diskette Drive Activity Light Does Not Light
Check the following:
T
Are the diskette drive's power and signal cables properly installed?
T
Are all relevant switches and jumpers on the diskette drive set correctly?
T
Is the diskette drive properly configured?
T
Is the diskette drive activity light always on? If so, the signal cable may be plugged in incorrectly.
If you are using the onboard diskette controller, use the BIOS setup to make sure that "Onboard Floppy" is set
to "Enabled." If you are using an add-in diskette controller, make sure that "Onboard Floppy" is set to
"Disabled."
CD-ROM Drive or DVD-ROM Drive Activity Light Does Not Light
Check the following:
T
Are the CD-ROM/DVD-ROM drive's power and signal cables properly installed?
T
Are all relevant switches and jumpers on the drive set correctly?
T
Is the drive properly configured?
Cannot Connect to a Server
T
Make sure the network cable is securely attached to the correct connector at the system back
panel.
T
Try a different network cable.
T
Make sure you are using the correct and the current drivers.
T
Make sure the driver is loaded and the protocols are bound.
T
Make sure the hub port is configured for the same duplex mode as the network controller.
T
Make sure the correct networking software is installed.
T
If you are directly connecting two servers (without a hub), you will need a crossover cable.
T
Check the network controller LEDs next to the NIC connectors.
Problems with Network
The server hangs when the drivers are loaded.
T
Certain drivers may require interrupts that are not shared with other PCI drivers. For these drivers,
it may be necessary to alter settings so that interrupts are not shared. See the documentation that
came with your PCI card(s) for information on changing interrupts.
Diagnostics pass but the connection fails.
T
Make sure the network cable is securely attached.
T
Make sure you specify the correct frame type in your NET.CFG file.
The controller stopped working when an add-in adapter was installed.
T
Make sure the cable is connected to the port from the onboard network controller.
T
Make sure your BIOS is current.
T
Make sure the other adapter supports shared interrupts. Make sure your operating system
supports shared interrupts.