Acer Altos R510, Руководство по обслуживанию

Страница: 90 / 143

83 Chapter 3
4. Remove the front bezel if it is installed. For instructions, see “Removing and Installing the Front Bezel.”
5. Push in on the blue lever at the rear of the DVD/CD-RW or CD-ROM drive carrier and push the carrier out
through the front of the chassis.
6. Align the two holes at left edge of DVD/CD-RW or CD-ROM drive with the cutouts in drive carrier. See
letter “A” in the figure below.
7. Lower the right side of the DVD/CD-RW or CD-ROM drive into the carrier until it clicks into place. See
letter “B” in the figure below.
8. Use the two screws indicated in the figure to attach the interpose board to the DVD/CD-RW or CD-ROM
drive. See letters “C” and “D” in the figure.
9. Insert the DVD/CD-RW or CD-ROM drive carrier into the chassis. See letter “A” in the figure below.
10. If it is not already connected, connect the 2x3 end of the DVD/CD-RW or CD-ROM drive power cable that
was included with your fixed drive kit to the 2x3 power connector on the SATA power adapter cable. See
letters “B” and “C” in the figure below.
11. Connect the drive power cable to the power connector on the rear of the DVD/CD-RW or CD-ROM drive.
See letter “D” in the figure.
12. Connect the DVD/CD-RW or CD-ROM drive data cable that was included with your kit between the
interposer board and the IDE connector on the server board. See letters “E” and “F” in the figure below.
See your server board documentation for assistance in locating the connector location on the server
board.
13. Route the DVD/CD-RW or CD-ROM drive data cable over the top of air baffle, as shown in the diagram
below.
14. Install the chassis cover. For instructions, see “Installing the Chassis Cover.”
15. (Optional) Install the front bezel. For instructions, see “Removing and Installing the Front Bezel.”
16. Plug all peripheral devices and the AC power cable back into the server.