79
Chapter 3
11.
Open the connector on the rear of the floppy drive by pulling up on the connector cover.
12.
Insert one end of the flat flex cable end into the floppy drive connector.
13.
Push down on the connector cover to lock the cable into place.
14.
Slide the carrier assembly into the left hard drive bay until it clicks into place. See letter “A” in the figure
below.
15.
Open the connector labeled “Floppy Con” on the backplane by pulling up on the connector cover. See
letter “B” in the figure below.
16.
Insert the loose end of the flat flex cable into the backplane connector. See letter “C” in the figure below.
17.
Push in on the connector cover to lock the cable into place. See letter “D” in the figure below.
18.
Install the chassis cover. For instructions, see
“Installing the Chassis Cover”
19.
(Optional) Install the front bezel. For instructions, see
“Removing and Installing the Front Bezel.”
20.
Plug all peripheral devices and the AC power cable back into the server.
Removing a Floppy Drive from the Converted Hard Drive Bay
1.
Observe the safety and ESD precautions at the start of this book.
2.
Power down the server and unplug all peripheral devices and the AC power cable.
3.
Remove the chassis cover. For instructions, see
“Removing the Chassis Cover.”
4.
Remove the front bezel if it is installed. For instructions, see
“Removing and Installing the Front Bezel.”
Содержание Altos R510
