Acer Altos R510, Руководство по обслуживанию

Страница: 82 / 143

75 Chapter 3
10. Store the floppy drive carrier and the flat flex cable for future use.
11. Install the slimline filler panel into slimline bay if no drive is to be installed into the bay.
12. Install the chassis cover. For instructions, see “Installing the Chassis Cover.”
13. (Optional) Install the front bezel. For instructions, see “Removing and Installing the Front Bezel.”
14. Plug all peripheral devices and the AC power cable back into the server.
Installing a Floppy Drive into Slimline Bay (No Backplane Installed)
NOTE: NOTE: The carrier for the slimline floppy drive that is used in these instructions was sent to you in the
hardware kit that came with your Altos R510 Server Chassis. The interposer board and floppy drive
power adapter cable used in these instructions was sent to you with your fixed drive kit.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety Information.”
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”
4. Remove the front bezel if it is installed. For instructions, see “Removing and Installing the Front Bezel.”
5. Align the two holes at the left side of the floppy drive with the two cutouts in the floppy drive carrier. See
letter “A” in the figure below.
6. Lower the right side of the floppy drive into the carrier until it clicks into place. See letter “B” in the figure
below.
7. Open the connector on the rear of the floppy drive by pulling up on the connector cover. See letter “A” in
the figure below.
8. Insert one end of the 26-pin flat flex cable end into the connector. See letter “B” in the figure below.
9. Push down on the connector cover to lock the cable into place. See letter “C” in the figure below.
10. Open the connector on the interposer board by pulling out on the connector cover. See letter “D” in the
figure below.
11. Insert the loose end of the floppy cable into the interpose board connector. See letter “E” in the figure
below.
12. Push in on the connector cover to lock the cable into place. See letter “F” in the figure below.
A
B