Acer Altos R510, Руководство по обслуживанию

Страница: 88 / 143

81 Chapter 3
Installing or Removing a DVD/CD-RW or CD-ROM Drive
CAUTION: CAUTION: DVD/CD-RW and CD-ROM drives are NOT hot swappable. Before removing or
replacing the drive, you must first take the server out of service, turn off all peripheral devices
connected to the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
Installing a DVD/CD-RW or CD-ROM Drive into Slimline Bay (Backplane
Installed)
NOTE: NOTE: The carrier for the slimline DVD/CD-RW drive / CD-ROM drive was pre-installed in the slimline
drive bay of your Altos R510 Server Chassis.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety Information.”
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”
4. Remove the front bezel if it is installed. For instructions, see “Removing and Installing the Front Bezel.”
5. Push in on the blue lever at the rear of the DVD/CD-RW / CD-ROM drive carrier and push the carrier out
through the front of the chassis.
6. Align the two holes at left edge of DVD/CD-RW /CD-ROM drive with the cutouts in drive carrier. See letter
“A” in the figure below.
7. Lower the right side of the DVD/CD-RW / CD-ROM drive into the carrier until it clicks into place. See letter
“B” in the figure below.
8. Use the two screws indicated in the figure to attach the interposer board to the DVD/CD-RW / CD-ROM
drive. See letters “C” and “D” in the figure.
9. Attach the 44-pin CD-ROM drive cable to the exposed side / back of the interposer board. See letter “E” in
the figure.
10. Slide the DVD/CD-RW / CD-ROM drive carrier into the chassis. See letter “A” in the figure below.
11. Connect the loose end of the CD-ROM drive cable to the backplane connector. See letter “B” in the figure.