Acer Altos R510, Руководство по обслуживанию

Страница: 89 / 143

Chapter 3 82
12. Install the chassis cover. For instructions, see “Installing the Chassis Cover.”
13. (Optional) Install the front bezel. For instructions, see “Removing and Installing the Front Bezel.”
14. Plug all peripheral devices and the AC power cable back into the server.
Removing a DVD/CD-RW or CD-ROM Drive from the Slimline Bay (Backplane
Installed)
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety Information.”
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”
4. Remove the front bezel if it is installed.
5. Disconnect the CD-ROM data cable from the backplane.
6. Push in on the blue lever at the rear of the drive carrier. Slide the drive carrier out through the front of the
chassis.
7. Press downward on the side of the carrier release the drive from the drive carrier.
8. Disconnect the data cable from the rear of the DVD/CD-RW or CD-ROM drive.
9. Remove the two screws at the rear of the DVD/CD-RW or CD-ROM drive to disconnect the interposer
board.
10. Store the screw and interposer board for future use. Suggestion: tape the screw to the drive carrier.
11. Slide the empty drive carrier into the chassis until it clicks into place.
12. Install the chassis cover. For instructions, see “Installing the Chassis Cover.”
13. (Optional) Install the front bezel. For instructions, see “Removing and Installing the Front Bezel.”
14. Plug all peripheral devices and the AC power cable back into the server.
Installing DVD/CD-RW or CD-ROM Drive into Slimline Bay (No Backplane
Installed)
NOTE: NOTE: The carrier for the slimline DVD/CD-RW drive / CD-ROM drive was pre-installed in the slimline
drive bay of your Altos R510 Server Chassis. The interposer board and floppy drive power adapter
cable used in these instructions was sent to you with your fixed drive kit.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety Information.”
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”
A
B