Acer Altos R510, Руководство по обслуживанию

Страница: 96 / 143

89 Chapter 3
Installing and Removing the SATA or SCSI Backplane (Optional)
You received your server chassis with your choice of one of drive installation options:
T
A hot-swap SCSI option that came with a SCSI backplane board.
T
A hot-swap SATA option that came with a SATA backplane board.
T
A fixed SATA drive option. This option does not include a board to install.
CAUTION: CAUTION: The backplane is NOT hot swappable. Before removing or replacing the backplane,
you must first take the server out of service, turn off all peripheral devices connected to the system, turn
off the system by pressing the power button, and unplug the AC power cord from the
system or wall outlet.
The backplane board and the hardware that came with the backplane can be replaced if your backplane fails
or if a different option is required. To replace the backplane, use the following instructions to remove and then
to install a backplane.
Removing the SATA or SCSI Backplane
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety Information.”
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”
4. Remove the air baffle. For instructions, see “Removing the Air Baffle.”
5. Remove all hot-swap drive carriers. For instructions, see “Removing a SATA or SCSI Hot-swap Hard Disk
Drive.”
6. Disconnect all cables from the backplane:
7. Loosen the blue captive screw at the right side of the backplane. See letter “A” in the figure below
8. Slide the board to the right until it stops. Do not pull on any components on the board – grasp only on the
edges of the board. See letter “B” in the figure.
9. Lift the backplane from the chassis. The holes in the backplane will slide from the matching pins in the
chassis. If any of the pins catches on the holes, it means you have not slid the board fully to the right. See
letter “C” in the figure.
C
A
B