85
Chapter 3
Installing and Removing a PCI Riser Connector
CAUTION:
CAUTION: PCI riser connectors are NOT hot swappable. Before removing or replacing the riser
connector, you must first take the server out of service, turn off all peripheral devices connected to the
system, turn off the system by pressing the power button, and unplug the AC power cord from the
system or wall outlet.
Installing a PCI Riser Connector
To install the PCI riser connector, use the following instructions.
1.
Observe the safety and ESD precautions at the beginning of this book. See
“Safety Information.”
2.
Power down the server and unplug all peripheral devices and the AC power cable.
3.
Remove the chassis cover. For instructions, see
“Removing the Chassis Cover.”
4.
Pull up on the two latches on the assembly. See letter “A” in the figure below.
5.
Lift the PCI riser assembly from the chassis.
6.
Line up the screws on the riser assembly with the slot and the large hole on the riser connector.
7.
Press and hold the blue riser locking lever. See letter “A” in the figure below.
8.
Place riser connector onto the retention pins.
9.
Slide the riser connector to the right to lock it into place.
10.
Release the blue locking lever.
11.
Install a PCI add-in card, if desired. For instructions, see
“Installing a PCI Add-in Card.”
12.
Position the riser assembly over the PCI sockets on the server board (see letter “A” in the figure below),
lining up the four hooks at the rear of the riser assembly (see letter “B”) with the four slots in the rear of the
chassis (see letter “C”).
13.
Push the riser assembly down until the assembly is securely seated.
Содержание Altos R510
