ABB Robotics IRB 6790, Руководство по эксплуатации продукта

Страница: 389 / 668

Note Action
Lifting accessory (chain): 3HAC15556-1 Fit the lifting accessory to the shackle and
raise to unload the weight. 3
Removing the rear shafts
Perform this procedure on both sides.
Note Action
VK cover, 90x12: 3HAA2166-36
Position for screwdriver:
xx1300000662
Remove the both VK covers using one of
the recommended methods:
• Drive a screwdriver (or similar)
through the VK cover, as close as
possible to the center of the VK
cover, and bend out the cover. If not
making a hole in the center of the
VK cover, there is a risk of damaging
the bearing inside. The damaged VK
cover must be replaced with a new.
• Remove the protection screw from
the vent hole and use air pressure
through the hole to blow out the
cover. The cover can be reused if
not damaged.
1
Vent hole for air pressure:
xx1700001800
Wipe off any residual grease inside the re-
cess. 2
Continues on next page
Product manual - IRB 6790 389
3HAC063331-001 Revision: B
© Copyright 2019 - 2020 ABB. All rights reserved.
4 Repair
4.6.2 Replacing the balancing device
Continued