Chapter 12. Troubleshooting
236
3ware Serial ATA RAID Controller User Guide
0036 Verify fixed data/parity mismatch
This message is sent by the controller when a verify error is found (parity
inconsistency for RAID 5/50 or data mismatch for RAID 1/10 configuration)
and recovered. If the error is not recovered the message Verify Failed is
returned instead.
0037 SO-DIMM not compatible
This message applies to the 3ware 9500S controller which has removable
memory. This message will be sent if there is incompatible SODIMM
memory connected to the controller. In this case, the controller is inoperable
and cannot be used until a compatible SO-DIMM is put on the controller. For
a list of SODIMMs compatible with the 9500S, see
http://www.3ware.com/KB/article.aspx?id=11748
.
Other 3ware controller models do not have memory that can be removed.
0038 SO-DIMM not detected
This message applies to the 3ware 9500S controller which has removable
memory. This message will be sent if there is no SODIMM memory
connected to the controller. In this case, the controller is inoperable and
cannot be used until a compatible SO-DIMM is put on the controller. For a list
of SODIMMs compatible with the 9500S, see
http://www.3ware.com/KB/article.aspx?id=11748
.
Other 3ware controller models do not have memory that can be removed.
0039 Buffer ECC error corrected
This message will be sent when the controller has detected and corrected a
memory ECC error.
003A Drive power on reset detected
If the controller detects that a drive has lost power and then restarted, it will
send this message. The controller may degrade the unit (if possible).
For troubleshooting information and a link to drive manufacturer diagnostic
utilities, see
http://www.3ware.com/KB/article.aspx?id=14927.
003B Rebuild paused
This message will be sent when the rebuild operation is paused.
Rebuilds are normally paused for ten minutes after a system first boots up and
during non-scheduled times when scheduling is enabled.
