ZyXEL Communications ZyWall USG 50-H Series, User Manual

Page: 454 / 704

Chapter 28 User/Group
ZyWALL USG 50-H User’s Guide
454
28.4.2 Force User Authentication Policy Add/Edit Screen
Use this screen to specify a condition when users must log in or do not have to log in to the
ZyWALL before their HTTP traffic can pass through the ZyWALL.
Figure 370 Object > User/Group > Setting > Force User Authentication Policy Add/Edit
The following table describes the labels in this screen.
28.4.3 User Aware Login Example
Access users cannot use the Web configurator to browse the configuration of the ZyWALL.
Instead, when access users log in to the ZyWALL (forced in the screen as shown in
Figure 368
on page 450 or otherwise), the following screen appears.
Table 162 Object > User/Group > Setting > Force User Authentication Policy Add/Edit
LABEL DESCRIPTION
Enable Select this if you want this condition to be active.
Description Enter a description for this condition. It can be up to 60 printable ASCII characters
long.
Authentication Select whether users must log in ( force ) or whether users do not have to log in
( skip ) when this condition is checked and satisfied.
Source Address Select a source IP address object or select Create Object to configure a new one.
Select any if this condition applies to traffic from all source addresses.
Destination
Address Select the destination address of traffic to which this condition applies or select
Create Object to configure a new one. Select any if this condition applies to traffic
from all destination addresses.
Schedule Select the schedule object that specifies when this condition applies or select
Create Object to configure a new one (see Chapter 31 on page 469 for details).
Select none if this condition always applies.
OK Select this to save your changes and return to the previous screen.
Cancel Select this to return to the previous screen without saving any changes.