Chapter 22 Policy Rule
XS1920 Series User’s Guide
181
Diffserv
Select
No change
to keep the TOS and/or DSCP fields in the packets.
Select
Set the packet’s TOS field
to set the TOS field with the value you configure in the
TOS
field.
Select
Replace the IP TOS with the 802.1p priority value
to replace the TOS field with
the value you configure in the
Priority
field.
Select
Set the Diffserv Codepoint field in the frame
to set the DSCP field with the value
you configure in the
DSCP
field.
Outgoing
Select
Send the packet to the mirror port
to send the packet to the mirror port.
Select
Send the packet to the egress port
to send the packet to the egress port.
Metering
Select
Enable
to activate bandwidth limitation on the traffic flow(s) then set the actions to
be taken on out-of-profile packets.
Out-of-profile
action
Select the action(s) to be performed for out-of-profile traffic.
Select
Drop the packet
to discard the out-of-profile traffic.
Select
Change the DSCP value
to replace the DSCP field with the value specified in the
Out of profile DSCP
field.
Select
Set Out-Drop Precedence
to mark out-of-profile traffic and drop it when network is
congested.
Select
Do not drop the matching frame previously marked for dropping
to queue the
frames that are marked to be dropped.
Add
Click
Add
to inset the entry to the summary table below and save your changes to the
Switch’s run-time memory. The Switch loses these changes if it is turned off or loses power,
so use the
Save
link on the top navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Cancel
Click
Cancel
to reset the fields back to your previous configuration.
Clear
Click
Clear
to set the above fields back to the factory defaults.
Index
This field displays the policy index number. Click an index number to edit the policy.
Active
This field displays
Yes
when policy is activated and
No
when is it deactivated.
Name
This field displays the name you have assigned to this policy.
Classifier(s)
This field displays the name(s) of the classifier to which this policy applies.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete
Click
Delete
to remove the selected entry from the summary table.
Cancel
Click
Cancel
to clear the
Delete
check boxes.
Table 79
Advanced Application > Policy Rule (continued)
LABEL
DESCRIPTION
Summary of Contents for XS1920 Series
