Chapter 9 VLAN
XS1920 Series User’s Guide
100
9.6 Configure VLAN Port Settings
Use the VLAN Port Setting screen to configure the static VLAN (IEEE 802.1Q) settings on a port.
Click the
VLAN Port Setup
link in the
VLAN Status
screen.
Association
VLAN List
Primary
private VLANs can associate with several (secondary)
Community
private VLANs
and up to one (secondary)
Isolated
private VLAN.
You only configure
VLAN Association List
for
Primary
private VLANs. Use a dash to
associate consecutive VLANs and a comma (no spaces) to associate non-consecutive VLANs.
For example, 51-53 includes 51, 52 and 53, but 51,53 does not include 52.
Secondary private VLANs can only be associated with one primary private VLAN.
Port
The port number identifies the port you are configuring.
*
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Control
Select
Normal
for the port to dynamically join this VLAN group using GVRP. This is the
default selection.
Select
Fixed
for the port to be a permanent member of this VLAN group.
Select
Forbidden
if you want to prohibit the port from joining this VLAN group.
Tagging
Select
TX Tagging
if you want the port to tag all outgoing frames transmitted with this
VLAN Group ID.
Add
Click
Add
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to change the fields back to their last saved values.
Clear
Click
Clear
to start configuring the screen again.
VID
This field displays the ID number of the VLAN group. Click the number to edit the VLAN
settings.
Active
This field indicates whether the VLAN settings are enabled (
Yes
) or disabled (
No
).
Name
This field displays the descriptive name for this VLAN group.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete
Click
Delete
to remove the selected entry from the summary table.
Cancel
Click
Cancel
to clear the
Delete
check boxes.
Table 38
Advanced Application > VLAN > VLAN Configuration > Static VLAN Setup (continued)
LABEL
DESCRIPTION
Summary of Contents for XS1920 Series
