ZyXEL Communications VES-1124 -, User Manual

Page: 165 / 203

VES-1124 User’s Guide
Introduction to CLI 24-11
Table 24-2 Command Summary: sys sw
COMMAND DESCRIPTION
bw The following commands relate
to defining a maximum allowable
bandwidth for incoming and/or
outgoing traffic flows for specified
ports.
display <port> Displays current run-time
bandwidth control settings.
set <port> <enable|disable> <ingress
rate[kbps]> <egress rate[kbps]>
Enables or disables bandwidth
control of ingress and/or egress
rates on individual ports.
trunk The following commands relate
to trunking. Trunking is the
grouping of physical ports into
one logical higher-capacity link.
del <id> Delete a trunk group.
display Displays current run-time trunk
settings.
listView Displays member list of trunk.
set <id> <port_no...> Sets members of a trunk group.
mc
set <addr> <port>... Sets ports to a specific multicast
address.
del <addr> Deletes a specific multicast
address.
get <addr> Shows a multicast address’s
forwarding ports.
vlan
status Displays VLAN status
type <802.1q | port-based> Sets VLAN mode
24.2.3 exit Command
Table 24-3 Command Summary: exit
COMMAND DESCRIPTION
exit Ends the console or telnet
session.
24.2.4 ip Commands