ZyXEL Communications VES-1124 -, User Manual

Page: 160 / 203

VES-1124 User’s Guide
24-6 Introduction to CLI
24.2.2 sys sw Commands
The following commands are system switch commands; all are preceded with
sys sw
Table 24-2 Command Summary: sys sw
COMMAND DESCRIPTION
driver config Shows the switch’s settings.
count disp Shows the switch Network Driver
Interface Specifications (NDIS)
level counters (CPU interface).
clear Clears the switch NDIS level
counters (CPU interface).
garp status Shows the GARP timer status.
timer <join timer(ms)><leave
timer(ms)><leave all timer<ms>
Sets the GARP timer’s Join
Timer, Leave Timer and Leave
All Timer.
gvrp trace Sets GVRP trace level.
status Shows the GVRP status.
enable Enables GVRP.
disable Disables GVRP.
pktcnt <port 1-26> Display port statistic counter.
pktcntclear <port 1-26> Reset port statistic counter.
pktsend
port <portID> <enable | disable> <Speed> <FlowCtrl> Port setup.
portstatus Displays current port status and
settings.
phyread <portID> [<phyAddr>] Reads PHY register.
phywrite <portID> <phyAddr> <data> Writes PHY register.
qos defpri <port> [<0:none | 1:low | 2:high>] Sets the default ingress User
Priority for a port.
map <0..7> [<0:low | 1:high>] Maps a User Priority to a Traffic
Class.
method <0:FCFS | 1:Strict | 2:WRR [high
weight] [low weight]>
Sets the QoS method.
showmethod Displays the QoS method.
vlan1q All “sys sw vlan1q” commands
relate to IEEE 802.1Q Tagged
VLAN configuration. Use “config
save” to save your configuration
changes.
port status <port> Shows a port’s VLAN
information.