ZyXEL Communications P-791R, User Manual

Page: 189 / 358

Chapter 22 Remote Node Setup
P-791R v2 User’s Guide
189
22.4 Remote Node Network Layer Options
Move the cursor to the Edit IP field in menu 11.1, then press [SPACE BAR] to select Yes .
Press
[ENTER]
to open Menu 11.3 - Remote Node Network Layer Options .
Figure 107 Menu 11.3: Remote Node Network Layer Options
Allocated
Budget(min)
Enter the maximum amount of time (in minutes) each call can last. Enter 0 if
there is no limit. With Period , you can set a limit on the total outgoing call time
of the ZyXEL Device within a certain period of time. When the total outgoing
call time exceeds the limit, the current call will be dropped and any future
outgoing calls will be blocked.
Period(hr) Enter how often (in hours) the Allocated Budget is reset. For example, if you
can call for thirty minutes every hour, set the Allocated Budget to 30, and set
this field to 1.
Schedule Sets Enter the schedule sets that apply to this connection.
Nailed-Up
Connection
Select this if you want the ZyXEL Device to automatically connect to your ISP
when it is turned on and to remain connected all the time. This is not
recommended if you pay for your Internet connected based on the amount of
time you are connected.
Session Options
Edit Filter Sets If you want to specify input and output filter sets for the WAN port, press
[SPACE BAR] to select Yes and press [ENTER]. Menu 11.5 appears.
Idle Timeout(sec) Enter the number of seconds the ZyXEL Device should wait while there is no
Internet traffic before it automatically disconnects from the ISP. Enter a time
interval between 10 and 9999 seconds.
Table 64 Menu 11.1: Remote Node Profile (node 8) (continued)
FIELD DESCRIPTION
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment = Static Ethernet Addr Timeout(min)= N/A
Rem IP Addr = 192.168.2.2
Rem Subnet Mask= 255.255.255.0
My WAN Addr= 192.168.2.1
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=