ZyXEL Communications P-791R, User Manual

Page: 182 / 358

Chapter 20 LAN Setup
P-791R v2 User’s Guide
182
Figure 102 Menu 3.2.1: IP Alias Setup
Use the instructions in the following table to configure IP alias parameters.
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Table 61 Menu 3.2.1: IP Alias Setup
FIELD DESCRIPTION
IP Alias 1, 2 Choose Yes to configure the LAN network for the ZyXEL Device.
IP Address Enter the IP address of your ZyXEL Device in dotted decimal notation.
IP Subnet Mask Your ZyXEL Device will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the ZyXEL Device.
RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP direction. Options are
Both , In Only , Out Only or None .
Version Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are
RIP-1 , RIP-2B or RIP-2M .
Incoming
protocol filters
Enter the filter set(s) you wish to apply to the incoming traffic between this node and
the ZyXEL Device.
Outgoing
protocol filters
Enter the filter set(s) you wish to apply to the outgoing traffic between this node and
the ZyXEL Device.
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to
save your configuration, or press [ESC] at any time to cancel.