ZyXEL Communications NAS Series, User Manual

Page: 182 / 364

Chapter 9 Network
Cloud Storage User’s Guide
182
The following table describes the labels in this screen.
9.7 Telnet/SSH Service Screen
Use this screen to enable or disable Telnet and SSH (Secure SHell) access to the NAS.
Telnet or SSH access lets you use line commands to configure the NAS. Use these commands at
your own risk. The vendor takes no responsibility for any changes you make using the commands.
Click Network > Telnet/SSH Service in the navigation panel to open the following screen.
Figure 86
Network > Telnet/SSH Service
Table 48
Network > PPPoE
LABEL DESCRIPTION
Status
Status This field displays the status of PPPoE connection.
IP Address This field displays the IP address of your PPPoE connection.
IP Subnet Mask This field displays the IP subnet mask of your PPPoE connection.
Default Gateway This field displays which network interface the NAS uses for PPPoE connections.
Configuration
Enable PPPoE
Connection Select this option to establish a direct Internet connection for the NAS. Select for which
Gigabit Ethernet interface to use PPPoE. You need to enter the username and password as
given by your ISP.
Username Enter the username exactly as your ISP assigned. If assigned a name in the form
user@domain where domain identifies a service name, then enter both components
exactly as given.
Password Enter the password associated with the username above.
Password
(Confirm)
Retype the password for confirmation.
Apply Click this to save your changes.
Reset Click this to restore previously saved settings.