ZyXEL Communications NAS Series, User Manual

Page: 181 / 364

Chapter 9 Network
Cloud Storage User’s Guide
181
9.6 PPPoE Screen
Use this screen to configure PPPoE settings for a direct Internet connection.
Click Network > PPPoE in the navigation panel to open the following screen.
Figure 85
Network > PPPoE
WAN Port When you enable WAN access for one of the NAS’s services, specify the port number
(1~65,536) Internet uses need to use to connect to the Internet gateway’s WAN port in
order to access the service on the NAS. Whoever wants to access a service on the NAS
from the Internet must use this port number.
P2P download’s WAN port must be the same as the LAN port.
Make sure there is not another service using TCP protocol with the same port number.
If another device is using the same port (the Internet gateway has the same port number
mapped to another LAN IP address), the NAS overwrites it when you apply the setting and
WAN users can no longer access the other device.
This icon means the service’s LAN and WAN port numbers must be the same.
This icon means another service is using the same port number as this service. Change
the port number of one of the services so they use different port numbers.
This icon means another service is using the listed port, but the port the other service is
using will be replaced if you apply the setting. The other service will no longer be
accessible from the listed port.
Apply Click Apply to save your changes back to the NAS.
Reset Click Reset to begin configuring this screen afresh.
Table 47
Network > UPnP > Port Mapping (continued)
LABEL DESCRIPTION