EMG6765-Q10A User’s Guide
30
5.3.1 Setting your EMG6765-Q10A to AP Mode
1
Log into the Web Configurator if you haven’t already. See the Quick start Guide for instructions on how
to do this.
2
To use your EMG6765-Q10A as an access point, go to
Maintenance > Sys OP Mode
and select
Access
Point Mode
.
Figure 11
Changing to Access Point mode
Note: You have to log in to the Web Configurator again when you change modes. As soon as
you do, your EMG6765-Q10A is already in Access Point mode.
3
When you select
Access Point Mode
, the following pop-up message window appears.
Figure 12
Pop up for Access Point mode
Click
OK
. Then click
Apply
. The Web Configurator refreshes once the change to Access Point mode is
successful.
5.3.2 Accessing the Web Configurator in Access Point Mode
Log in to the Web Configurator in Access Point mode, do the following:
1
Connect your computer to the LAN port of the EMG6765-Q10A.
2
The default IP address of the EMG6765-Q10A is “192.168.1.2”. In this case, your computer must have an
IP address in the range between “192.168.1.3” and “192.168.1.254”.
3
Click
Start > Run
on your computer in Windows. Type “cmd” in the dialog box. Enter “ipconfig” to show
your computer’s IP address. If your computer’s IP address is not in the correct range then see
for information on changing your computer’s IP address.
4
After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and type
“192.168.1.2” as the web address in your web browser.
