Index
128
025-9567E
8.
After reinstalling the encoder, the encoder parameter memory will need to be partially
cleared and reprogrammed. The following sections of programming must be cleared:
block/format
remote control
send parameters
The clearing process is described in detail in “PROGRAMMING SECTION 1 -
CLEARING AND INITIALIZING” on page 67. In short, the process consists of entering
the clear mode and selecting the “
CLEAR SECTIONS 2, 5, AND 6
” option by keying
in the selection number “1”. The programming of the tone format selection, remote
control, and general and send button setup is described in detail in either the
“PROGRAMMING ENCODER FROM FRONT PANEL” section (page 65) or the
“PROGRAMMING ENCODER FROM SERIAL PORT” section (page 99).
9.
The new EPROMs may contain upgraded versions of the operational software. If the
operational software has changed, then a description of the changes will have been
included with the new EPROMs. The operation change description should be attached to
this manual. In some cases, new manuals will be included with the EPROMs, in which
case the new manual would supersede this manual.
Summary of Contents for Model 25
